Doosan DX150LC-9C Fault Code E000110-12: Complete Diagnostic Guide

What is Doosan DX150LC-9C Fault Code E000110-12?

Fault Code E000110-12 indicates a problem with the Engine Coolant Temperature (ECT) sensor circuit, specifically reporting a voltage level that is below the normal operating range or an open circuit condition. This diagnostic trouble code (DTC) is generated by the Electronic Control Module (ECM) when it detects an abnormal signal from the coolant temperature sensor that monitors engine operating temperature.

The ECT sensor plays a critical role in the DX150LC-9C's engine management system. It provides real-time temperature data that the ECM uses to adjust fuel injection timing, idle speed, and emissions control. When this sensor circuit fails, the ECM cannot properly regulate engine performance, potentially leading to poor fuel economy, rough idling, or inadequate engine protection from overheating.

Common Symptoms

When fault code E000110-12 is active on your Doosan DX150LC-9C, you may experience:

• Check Engine light or warning lamp illuminated on the instrument cluster
• Hard starting or extended cranking time, especially in cold conditions
• Rough idle or unstable engine RPM when the machine is at operating temperature
• Black smoke from the exhaust due to improper fuel mixture calculations
• Engine derate mode or reduced power output as a protective measure

Potential Causes

The most common technical reasons for E000110-12 appearing on used excavators include:

• Faulty ECT sensor with internal resistance breakdown (common after 5,000+ operating hours)
• Damaged wiring harness or corroded connections between the sensor and ECM
• Broken or frayed sensor wires at known rub points near the engine block or frame rails
• Corroded connector pins at the ECT sensor plug due to coolant leaks or moisture intrusion
• Poor ground connection affecting the sensor's reference voltage circuit
• ECM internal fault (rare, but possible in high-hour machines with electrical history)

How to Troubleshoot and Fix Code E000110-12

Step 1: Visual Inspection Begin by locating the ECT sensor on the engine block (typically near the thermostat housing). Inspect the sensor connector for corrosion, coolant contamination, or pushed-back pins. Check the wiring harness from the sensor back to the ECM for visible damage, particularly at flex points and areas where the harness contacts the frame. On used excavators, pay special attention to chafed insulation where harnesses run along sharp metal edges.

Step 2: Electrical Testing Disconnect the ECT sensor connector and use a digital multimeter to measure sensor resistance. At room temperature (68°F/20°C), resistance should typically read between 2,000-3,000 ohms (consult your service manual for exact specifications). Test the harness side for continuity between the sensor connector and the ECM pins. Check for short circuits to ground and verify reference voltage (typically 5 volts) from the ECM when the key is on.

Step 3: Component Replacement and Verification If the sensor tests out of specification, replace the ECT sensor using a genuine Doosan part or quality OEM equivalent. Before installation, apply dielectric grease to connector pins to prevent future corrosion. If the sensor tests good but the harness shows resistance or intermittent continuity, repair or replace the affected wiring section. After repairs, clear the fault code using Doosan diagnostic software (DMS) or a compatible scan tool, then perform a test run to verify the code does not return.

---

Disclaimer: This guide provides general diagnostic information for fault code E000110-12. Always consult the official Doosan service manual for your specific machine serial number and software version. If you're uncomfortable performing electrical diagnostics, contact a certified Doosan technician or qualified heavy equipment mechanic to avoid causing additional damage to the electrical system.