What is Doosan DX215-9C Fault Code E000175-01 (P0195)?

Fault Code E000175-01 (P0195) indicates an Engine Oil Temperature (EOT) Sensor Circuit Malfunction in the Doosan DX215-9C excavator. This diagnostic trouble code (DTC) is triggered when the Electronic Control Module (ECM) detects an abnormal voltage signal from the engine oil temperature sensor circuit, typically falling outside the expected range of 0.5-4.5 volts.

The engine oil temperature sensor plays a critical role in the DX215-9C's Doosan DL08 engine management system. It monitors oil viscosity conditions and helps the ECM optimize fuel injection timing, idle speed control, and emission system performance. When this sensor circuit fails, the ECM cannot accurately assess oil temperature, potentially leading to inefficient combustion, increased wear, and reduced engine protection during cold starts or high-load operations.

Common Symptoms

When Code E000175-01 appears on your Doosan DX215-9C, operators typically experience:

• Warning lamp illumination on the instrument cluster (check engine light or malfunction indicator)
• Hard starting conditions, especially in cold weather, due to improper fuel delivery calibration
• Rough idle or unstable engine RPM during warm-up periods
• Engine derate mode activation in severe cases, limiting maximum power output to protect components
• Increased black smoke emissions from incomplete combustion caused by incorrect fuel mapping

Potential Causes

The most common technical reasons for this fault code in used Doosan DX215-9C excavators include:

• Failed engine oil temperature sensor due to internal element degradation (common after 5,000+ operating hours)
• Corroded or damaged wiring harness connectors at the sensor location near the oil filter housing—a known wear point on this model
• Chafed or pinched sensor wiring where the harness passes through the engine mounting brackets
• ECM internal circuit failure (rare, but possible in high-hour machines)
• Contaminated sensor threads with carbon buildup or metallic debris causing poor ground connection
• Aftermarket oil filter installations that may have damaged sensor wiring during previous maintenance

How to Troubleshoot and Fix Code E000175-01 (P0195)

Step 1: Visual Inspection Begin by locating the EOT sensor on the driver's side of the engine block, near the oil filter assembly. Inspect the two-pin connector for corrosion, bent pins, or oil contamination. Check the entire wiring harness for abrasion points, especially where it contacts the engine block or frame rails—a common failure point on used excavators.

Step 2: Electrical Testing Disconnect the sensor and use a digital multimeter to measure resistance across the sensor terminals. At 68°F (20°C), resistance should read approximately 2,200-2,800 ohms. Values significantly outside this range indicate sensor failure. Next, check the harness-side connector voltage: with the ignition on (engine off), you should see approximately 5 volts reference voltage from the ECM.

Step 3: Circuit Continuity Check Test for continuity and shorts in the wiring between the sensor connector and the ECM connector J1 (pins 23 and 45 on DX215-9C models). Resistance should be less than 5 ohms for each wire, with no continuity to ground when disconnected.

Step 4: Sensor Replacement and Calibration If the sensor tests faulty, replace it with a genuine Doosan part (P/N 2872917) to ensure proper resistance curves. Apply anti-seize compound to threads and torque to 15-18 lb-ft. After installation, clear codes using Doosan G-SCAN diagnostic software and perform a cold-start verification test.

Used Equipment Tip: Before replacing components, thoroughly clean all connectors with electrical contact cleaner and inspect for "green corrosion" typical in machines operating in coastal or high-humidity environments.

---

Disclaimer: This guide provides general troubleshooting information. Always consult the official Doosan service manual for your specific serial number range and consider professional diagnostic services for complex electrical issues or if you lack proper diagnostic equipment.