Doosan DX230LC-9C Fault Code E000108-01: Complete Diagnostic Guide

What is Doosan DX230LC-9C Fault Code E000108-01?

Fault Code E000108-01 indicates a Swing Motor Pressure Sensor Circuit malfunction in the Doosan DX230LC-9C excavator's hydraulic system. This diagnostic trouble code (DTC) is triggered when the Electronic Control Module (ECM) detects an abnormal voltage signal from the swing motor pressure sensor, typically indicating an open circuit, short circuit, or sensor failure.

The swing motor pressure sensor is critical for monitoring hydraulic pressure during upper structure rotation. The ECM uses this data to optimize swing performance, prevent over-pressure conditions, and protect the hydraulic system from damage. When this sensor fails or its circuit is compromised, the machine may enter a protective derate mode to prevent potential damage to expensive hydraulic components.

Common Symptoms

When Code E000108-01 is active, operators typically experience:

• Warning light illuminated on the instrument cluster with accompanying fault code display
• Reduced swing speed or sluggish rotation performance due to ECM limiting hydraulic flow
• Intermittent or complete loss of swing function during operation
• Error message displayed on the monitor panel indicating hydraulic system fault
• Abnormal swing motor operation, including jerky or inconsistent rotation movements

Potential Causes

The most common technical causes for this fault code in used Doosan DX230LC-9C excavators include:

• Faulty swing motor pressure sensor due to internal component degradation or contamination from hydraulic fluid breakdown
• Damaged or corroded wiring harness connections at the sensor connector, especially common where harnesses route near the swing bearing
• Open or short circuit in the sensor signal wire caused by cable chafing against the swing motor housing or frame
• Corroded or loose connector pins at the sensor or ECM interface due to moisture intrusion
• Failed ECM (rare) with internal circuit board damage affecting the sensor input channel
• Hydraulic contamination causing sensor membrane failure in high-hour used machines

How to Troubleshoot and Fix Code E000108-01

Step 1: Visual Inspection Begin by inspecting the swing motor pressure sensor location and all associated wiring. On used excavators, check for obvious harness wear points where cables contact the swing motor or cross the center joint. Look for oil contamination, damaged insulation, or corroded connectors.

Step 2: Electrical Testing Using a digital multimeter, disconnect the sensor connector and measure resistance across the sensor terminals. Compare readings against Doosan specifications (typically 250-350 ohms at 20°C). Check for voltage supply at the harness connector—you should see approximately 5V reference voltage from the ECM with ignition on.

Step 3: Circuit Continuity Check Test continuity between the sensor connector and ECM pins to identify breaks in the signal or ground wires. Pay special attention to the harness routing through the swing bearing area where flexing causes wire fatigue in older machines.

Step 4: Sensor Replacement or Repair If electrical tests confirm sensor failure, replace the swing motor pressure sensor with a genuine Doosan part. Before installation on used equipment, thoroughly clean the mounting port and apply thread sealant to prevent hydraulic leaks. If wiring damage is found, repair using proper gauge wire and weatherproof connectors, ensuring adequate strain relief.

Step 5: Clear Codes and Test After repairs, use Doosan diagnostic software (DMS-5) or the machine's built-in diagnostic menu to clear fault codes. Perform a complete swing operation test under various loads to verify proper sensor function and ensure no code recurrence.

---

Disclaimer: This guide provides general diagnostic information. Always consult the official Doosan service manual for your specific serial number and consider professional diagnosis for complex hydraulic or electrical issues, especially on used machinery with unknown maintenance history.