Doosan Excavator Fault Code E000110-31: Complete Diagnostic Guide

What is Doosan Fault Code E000110-31?

Fault Code E000110-31 indicates a short circuit to ground (low voltage) in the Engine Oil Pressure Sensor circuit. This code is triggered when the Electronic Control Module (ECM) detects an abnormally low voltage signal from the oil pressure sensor, typically below the manufacturer's specified threshold of 0.5 volts.

The engine oil pressure sensor is a critical component in Doosan excavators that monitors lubrication system performance. This sensor sends real-time voltage signals to the ECM, which uses this data to protect the engine from catastrophic damage due to insufficient oil pressure. When this circuit shorts to ground, the ECM cannot accurately monitor oil pressure, potentially putting the entire powertrain at risk.

For used excavators, this fault is particularly concerning because it may mask actual low oil pressure conditions, leaving operators unaware of developing lubrication failures that could cause engine seizure or bearing damage.

Common Symptoms

• Engine warning light or check engine light illuminated on the instrument cluster
• Engine derate mode activated, limiting machine power output to protect components
• Erratic or zero oil pressure readings displayed on the dashboard gauge
• Possible engine shutdown or failure to start, depending on ECM programming and safety protocols
• Intermittent fault code appearance, especially during machine vibration or temperature changes

Potential Causes

Damaged or chafed wiring harness is the most common issue in used machines, particularly where the harness routes near hot engine components or vibrating brackets. The insulation deteriorates over time, allowing bare wires to contact grounded metal surfaces.

Corroded or moisture-contaminated connectors at the oil pressure sensor frequently cause ground shorts, especially on excavators operated in wet or humid conditions.

Failed oil pressure sensor with internal short circuit to the sensor body (ground).

Pinched wiring during previous maintenance or component replacement, creating intermittent ground contact.

ECM internal fault (rare) where the sensor input circuit has failed.

How to Troubleshoot and Fix Code E000110-31

Step 1: Visual Inspection Begin with a thorough inspection of the oil pressure sensor wiring harness from the sensor to the ECM connector. Look for obvious damage, melted insulation, or wires rubbing against sharp edges. On used excavators, pay special attention to areas where harnesses pass near exhaust manifolds or hydraulic lines that may have shifted over time.

Step 2: Connector and Sensor Check Disconnect the oil pressure sensor connector and inspect for corrosion, bent pins, or moisture intrusion. Clean contacts with electrical contact cleaner. Measure sensor resistance using a digital multimeter—typical specifications range from 50-250 ohms depending on oil temperature, but consult your service manual for exact values.

Step 3: Circuit Voltage Testing With the sensor disconnected and ignition on (engine off), measure voltage at the ECM supply wire (typically the reference voltage wire). You should see approximately 5 volts. If voltage is present, reconnect the sensor and measure the signal wire voltage with the engine running—it should fluctuate between 0.5-4.5 volts based on oil pressure.

Step 4: Ground Short Test With the sensor disconnected, use your multimeter in continuity mode to check for shorts between the signal wire and ground. Any continuity indicates a wiring harness short that must be located and repaired.

Step 5: Component Replacement If wiring and connectors test correctly, replace the oil pressure sensor with a genuine Doosan part. For used machines, always replace the sensor connector pigtail simultaneously, as connector degradation often causes repeat failures.

Professional Tip: Before replacing expensive components, check Technical Service Bulletins (TSBs) for your specific Doosan model—some serial number ranges have known harness routing issues with factory-recommended repair procedures.

---

Disclaimer: This guide provides general diagnostic information. Always consult your Doosan service manual and consider professional diagnosis for complex electrical issues. Improper repairs may cause engine damage or void warranties.