What is John Deere E240LC Fault Code 003587.06?

Fault Code 003587.06 indicates a "Swing Motor 2 Solenoid Valve - Current Below Normal or Open Circuit" condition on the John Deere E240LC excavator. This code is triggered when the Electronic Control Module (ECM) detects insufficient electrical current flowing through the swing motor solenoid valve circuit, or when the circuit is completely open (disconnected).

This fault specifically affects the hydraulic swing system, which controls the upper structure rotation of the excavator. The solenoid valve regulates hydraulic flow to the swing motor, and when the ECM cannot properly energize this valve due to low current or an open circuit, swing performance becomes compromised or completely inoperative. For the E240LC's sophisticated hydraulic management system, maintaining proper electrical communication with all solenoid valves is critical for coordinated machine operation and operator safety.

Common Symptoms

• Swing function inoperative or severely restricted – the upper structure may not rotate at all or exhibit sluggish, jerky movement
• Warning light illuminated on the instrument cluster, often accompanied by an audible alarm
• Derated machine performance – the ECM may limit other hydraulic functions as a protective measure
• Intermittent swing operation – function works sporadically, especially when the machine is cold or after sitting overnight
• Error message displayed on the monitor screen specifically referencing swing system malfunction

Potential Causes

The most common technical causes for code 003587.06 on used E240LC excavators include:

• Damaged or corroded wiring harness at known rub points near the swing bearing or along the upper structure frame rails
• Failed swing motor solenoid valve coil due to age, heat exposure, or moisture infiltration
• Corroded or loose electrical connectors at the solenoid valve or main harness junction points
• Broken or chafed wires in the swing motor harness, particularly where cables flex during rotation
• ECM internal fault or poor ground connections at the controller mounting location
• Blown fuse or damaged relay in the swing circuit protection system

How to Troubleshoot and Fix Code 003587.06

Step 1: Visual Inspection Begin with a thorough inspection of the swing motor solenoid valve harness. On used excavators, check for wire chafing where the harness passes through the swing bearing area and along mounting brackets. Look for corroded connectors, damaged insulation, or signs of previous repair attempts. Clean all connector pins with electrical contact cleaner and verify secure connections.

Step 2: Electrical Testing Using a digital multimeter, disconnect the solenoid valve connector and measure resistance across the solenoid coil terminals. Typical readings should be 3-8 ohms (consult service manual for exact specifications). An infinite reading indicates an open circuit within the coil. Next, check for supply voltage at the harness connector with the key on – you should see battery voltage (12-14V). Also verify proper ground continuity (less than 1 ohm resistance to chassis ground).

Step 3: Advanced Diagnostics Connect John Deere Service Advisor or compatible diagnostic software to access live data from the ECM. Monitor the commanded current versus actual current to the swing solenoid. A significant discrepancy confirms either wiring issues or solenoid failure. Check for intermittent faults by wiggling harnesses while monitoring. For used machines, inspect the swing bearing seal area for hydraulic fluid contamination of electrical components.

Step 4: Component Replacement If testing confirms solenoid failure, replace the swing motor solenoid valve assembly with genuine John Deere parts. When replacing wiring, use abrasion-resistant harness wrap at known wear points and secure with proper routing clips. After repairs, clear codes, cycle the swing function through full rotation in both directions, and verify code does not return.

---

Disclaimer: This guide provides general troubleshooting information. Always consult the official John Deere service manual for your specific machine serial number. If unfamiliar with hydraulic or electrical systems, consult a certified John Deere technician to prevent injury or further equipment damage.