What is Komatsu PC210LC-10 Fault Code L03DA22KK?

Fault Code L03DA22KK indicates a communication error or abnormal signal detected in the machine monitoring system (Komtrax) data transmission circuit on the Komatsu PC210LC-10 excavator. This code specifically relates to the communication link between the engine controller (ECM), the main monitor controller, and the Komtrax telematics module, which transmits operational data for remote monitoring.

This fault is critical because the PC210LC-10 relies on continuous data exchange between control modules to optimize engine performance, track machine health, and provide real-time diagnostics. When communication breaks down, operators may lose access to vital machine information, and in some cases, the excavator may enter a derated power mode to protect systems from potential damage due to incomplete monitoring data.

Common Symptoms

When fault code L03DA22KK is active, operators typically experience:

• Warning light illuminated on the main monitor display, often accompanied by a communication error message
• Intermittent or complete loss of machine data on the monitor screen (engine temperature, fuel level, operating hours)
• Komtrax system failure to transmit data to fleet management platforms or remote monitoring services
• Reduced engine power or derate mode activation in severe cases where the ECM cannot verify safe operating conditions
• Error codes stacking with other communication-related faults, indicating widespread network issues

Potential Causes

The most common technical reasons for this fault code on used PC210LC-10 excavators include:

• Corroded or loose connectors at the ECM, monitor controller, or Komtrax module—especially on machines operating in high-moisture or coastal environments
• Damaged CAN bus wiring harness, particularly at known rub points near the engine bay and along the upper structure rotation area
• Failed Komtrax communication module due to age, moisture intrusion, or component degradation in older units
• ECM software version mismatch or corrupted firmware requiring reprogramming
• Faulty ground connections at the main control module, which are prone to corrosion on used equipment
• Voltage supply issues to the communication modules from weak batteries or failing alternators

How to Troubleshoot and Fix Code L03DA22KK

Step 1: Connect Komatsu Diagnostic Software Use Komatsu KOMPC or an approved diagnostic tool to read active and stored codes. Check communication status between all control modules and verify which specific circuit is failing.

Step 2: Inspect Physical Connections Examine all harness connectors at the ECM (located right side of engine), main monitor controller (cab area), and Komtrax module (typically mounted under the operator seat or rear cover). Look for corrosion, bent pins, or moisture intrusion—common issues on used excavators. Clean connectors with electrical contact cleaner and apply dielectric grease.

Step 3: Test CAN Bus Wiring Using a multimeter, verify CAN-High and CAN-Low wire resistance (should read approximately 60 ohms between terminals when system is off). Inspect wiring for chafing, cuts, or damage at flex points, especially where harnesses route through the swing bearing area.

Step 4: Check Power Supply and Grounds Verify battery voltage (should be 12.5-13V minimum with engine off, 14V+ running). Inspect ground connections at the frame and ensure tight, corrosion-free contact. Poor grounds are frequent culprits in communication faults on older machines.

Step 5: Update or Reprogram ECM If wiring and connections check out, the ECM or Komtrax module may require software updates or reprogramming through authorized Komatsu diagnostic equipment.

For used excavators, always prioritize inspecting harness wear points and connector condition before replacing expensive modules. Many communication faults stem from preventable environmental damage rather than component failure.

---

Disclaimer: This guide provides general diagnostic information. Always consult the Komatsu PC210LC-10 service manual and consider professional technician support for complex electrical diagnostics and repairs.